LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2018 >> Forte LX, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (Engine Control System Diagnosis - 2.0L GDI (3 Of 3)) >> DTC P2127: Accelerator Position Sensor 2 Signal Circuit Low Input >> DTC Inspection >> Monitor KDS Data

Monitor KDS Data

WARNING: This page is about a different variant/trim than selected.
  1. Connect KDS to Data Link Connector (DLC).
  2. Warm up the Engine to normal operating temperature.
  3. Monitor the "APS" parameter on the "Current data" with KDS.
    Fig 1: Screen Display - Normal Data Of APS At Idle
    G12150454Courtesy of KIA MOTORS AMERICA, INC.
  4. Is parameter displayed within specifications?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM/PCM's connector or was repaired and ECM/PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals