Checking the control module connectors

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Connecting Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Connecting Control Module

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.
• Check control module connector terminal #7 for contact resistance and oxidation and for loose connections. Remedy Contact resistance and oxidation . Remedy loose connections according to Loose connections (terminals) .
• Connect the control module.
• Connect the stop (brake) lamp switch
• Connect the Volvo Scan Tool (ST) to the data link connector (DLC).
• Ignition on.
  Fig 4: Identifying 14-Pin Connector

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 5: Identifying Scan Tool

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  • Activate the Scan Tool (ST) in MODE 2.
  • Set the switch to the OFF position.
  • Depress the brake pedal.
  • Check whether response code 1-3-2 is obtained.

Is response code 1-3-2 obtained? 

• YES 

  Refer to Fault-tracing information 

• NO 

  Refer to Replacing the component