LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 1998 >> V70 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Computer Relearn Procedures) >> MAZDA >> Immobilizer System (626) >> Steering Lock Replacement (Customer Supplied 2 Or More Valid Keys)

Steering Lock Replacement (Customer Supplied 2 Or More Valid Keys)

WARNING: This page does not describe the selected car, but rather 126 other vehicles, including the 1999 Volvo V70, 1999 Volvo S80, 1999 Volvo S70, 1999 Volvo C70, and 1999 Volkswagen Passat. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove old steering lock. Remove steering lock coil. Install steering lock and steering lock coil. Connect harness connectors.
  2. Insert valid 1st key into old steering lock. Insert new key into new steering lock. Turn new key to ON position, then to LOCK position 5 times. Turn new key to ON position. SECURITY light should illuminate. Turn new key to LOCK position. SECURITY light should go out.
  3. Remove valid 1st key from old steering lock. Place valid 2nd key in old steering lock. Using new key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn new key to LOCK position.
  4. Disconnect coil connector from old steering lock and connect to new steering lock. Using new key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn new key to LOCK position and remove key.
  5. Repeat step 4)  with each new key. Wait 30 seconds, program will quit automatically. Complete installation of steering lock.