Headlamps: Adjusting
NOTE:
- The adjustment of the individual headlights can only be performed when the service function "headlight adjustment" is selected on the communication system.
Additional information concerning communication system see → The Communication system
Unlocking headlight
- Perform the following work procedure:
- Switch ignition on.
First initial screen "Welcome" will appear on display
- Press function button "Settings" - 1 -.
- Select Continue button in menu
- Press button on right next to display "Maintenance / Service"
- Press button on left next to display "Headlights". This action will cause headlight washer jets to raise where they will remain until button is operated again or ignition is switched on again.
The headlight adjustment can now be corrected.
After procedure has been completed, headlights are mechanically locked again by repeatedly pressing the button.
Adjusting left main headlight
Both adjustment screws on right-hand headlight are similar.
- Turn the adjusting screws for lateral adjustment - 1 - and for height adjustment - 2 - until the specified setting is achieved.
Hi beam headlight (right):
The left fog lamp adjustment is in the same location, but reversed.
NOTE:
- The high-beam headlight can only be adjusted vertically. Lateral adjustment is pre-adjusted and must not be changed.
- If the vehicle is equipped with separate low beams and high beams, high beam must be adjusted extra. Note that the adjuster must be set to 0% when adjusting the high beams.
- Turn screwdriver - 1 - to adjust height (range) of headlight.
Fog light (right)
- To adjust the fog lamp, unclip the cover from the lower part of the bumper cover in the center of the vehicle.
- Turn adjustment screw - 1 - toward right to lower beam range. Lateral adjustment is not possible.
The left fog lamp adjustment is in the same location, but reversed.