Inspection [06/2016 - ]: Procedure
- INSPECT IGNITION OR STARTER SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition All combinations of all terminals LOCK 10 kΩ or higher 2 (AM2) - 3 (ACC) ACC Below 1 Ω 2 (AM2) - 3 (ACC) - 4 (IG1)
6 (IG2) - 7 (AM1)ON Below 1 Ω 1 (ST1) - 2 (AM2) - 4 (IG1)
6 (IG2) - 7 (AM1) - 8 (ST2)START Below 1 Ω TEXT IN ILLUSTRATION*a Component without harness connected
(Ignition or starter Switch Assembly)If the result is not as specified, replace the ignition or starter switch assembly.
- Measure the resistance according to the value(s) in the table below.