Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during steering sensor removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Memorize steering angle neutral point | Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [11/2015 - 07/2020] |
| Intelligent clearance sonar system | |||
| Simple advanced parking guidance system | |||
| Pre-collision system | |||
| Initialize back door lock | Power door lock control system | Refer to INITIALIZATION [11/2015 - ] | |
| Replacement of steering sensor | Steering angle neutral point (Initialize intelligent clearance sonar system) |
|
Refer to CALIBRATION [11/2015 - 12/2018] |
NOTE:
If both the spiral cable sub-assembly and the steering sensor are malfunctioning, replace them with a new spiral cable with sensor sub-assembly.