Safety Connect System: Precaution: Precaution

IGNITION SWITCH EXPRESSION

HINT:

The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this information.

Expression	Ignition Switch (position)	Engine Switch (condition)
Ignition Switch off	Off	Off
Ignition Switch ON	ON	On (IG)
Ignition Switch ACC	ACC	On (ACC)
Engine Start	START	Start

WHEN AUTOMATIC COLLISION NOTIFICATION HAS ACTIVATED
1. Perform "ACN CALL END" with the Techstream to terminate ACN (Automatic Collision Notification) with the call center. Refer to ACN CALL END .
2. The BUB (Back-Up Battery) must be replaced.
WHEN DISCONNECTING CONNECTORS FROM DCM
1. The ignition switch must be off.
WHEN REPLACING THE DCM (TELEMATICS TRANSCEIVER)
1. After installing a new Telematics Data Communication Module (DCM [Telematics Transceiver]), perform "DCM ACTIVATION" with the Techstream. Refer to DCM ACTIVATION . This allows the Telematics service provider to register the new DCM (Telematics Transceiver) and to clear the old DCM (Telematics Transceiver) information from its database.
  NOTE:
  Do not replace the DCM (Telematics Transceiver) with one from another vehicle.
WHEN UNABLE TO CONTACT CALL CENTER BUT NO DTC OUTPUT
1. This may occur when the cellular signal intensity is very weak. Check "DCM OPERATION HISTORY" with the Techstream. Refer to DCM OPERATION HISTORY .
2. Contact the TSP (Telematics Service Provider / call center) to confirm the contract status and call center server status.
WHEN DIAGNOSING DCM (TELEMATICS TRANSCEIVER)
1. While attempting to diagnose the DCM (Telematics Transceiver), do NOT exchange the DCM (Telematics Transceiver) with one from another vehicle. Each DCM (Telematics Transceiver) is registered to a specific VIN and should not be tested in another vehicle.