Inspection Procedure
WARNING: This page is about a different car, the 2006 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (NAVIGATION CONTROLLER - MULTI-DISPLAY)
- Disconnect the multi-display connector E8 and navigation controller connector E18.
- Measure the resistance according to the value(s) in the table below.STANDARD RESISTANCE SPECIFIED CONDITION
Tester connection Condition Specified condition RE1 - RE Always Below 1 SG - SGND Always Below 1 RE1 - Body ground Always 10 k or higher SGND - Body ground Always 10 k or higher
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE