Inspection Procedure

WARNING: This page is about a different car, the 2006 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT CLOCK ASSEMBLY

Disconnect the clock assembly connector E5.

Fig 1: Disconnecting Clock Assembly Connector E5
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance according to the value(s) in the table below.

STANDARD RESISTANCE SPECIFIED CONDITION

Tester connection	Condition	Specified condition
E - Body ground	Always	Below 1

Measure the voltage according to the value(s) in the table below.

STANDARD VOLTAGE SPECIFIED CONDITION

Tester connection	Condition	Specified condition
B - E	Always	10 to 14 V
ACC - E	Ignition switch on (ACC)	10 to 14 V

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE