LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2005 >> Sienna XLE, FWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Door Lock Control System - Diagnostics >> Power Door Lock Control System >> Terminals Of Ecu

Terminals Of Ecu

  1. CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSY (MULTIPLEX NETWORK BODY ECU) 
    Fig 1: Checking Instrument Panel Junction Block Assy (Multiplex Network Body ECU)
    G02630580Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the 1C, 1J, 1L, 1K, 1P, B6, B7 and B9 J/B connectors.
    2. Check the voltage and resistance between each terminal of the wire harness side connectors and the body ground.

      Standard: 

      Fig 2: Checking Voltage And Resistance Between Terminal Of Wire Harness Side Connectors And Body Ground Table (Disconnect Connectors)
      G02630581Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      * w/o Power back door

      If the result is not as specified, there may be a malfunction on the wire harness side.

    3. Reconnect the connectors, and check the voltage between each terminal of the connectors and the body ground.

      Standard: 

      Fig 3: Checking Voltage And Resistance Between Terminal Of Wire Harness Side Connectors And Body Ground Table (Reconnect Connectors)
      G02630582Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      * w/o Power Back Door

      HINT:

      Use an oscilloscope to check the output voltages of the terminals LSWD, LSWP, LSWL and LSWR.

      If the result is not as specified, the J/B assy (body ECU) may have a malfunction.

  2. w/ Power back door: 

    CHECK POWER BACK DOOR ECU 

    Fig 4: Identifying Power Back Door ECU (With Power Back Door)
    G02630583Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the P13 and P14 ECU connectors, and check the voltage or resistance of each terminal of the wire harness side connectors.

      Standard: 

      Fig 5: Checking Voltage Or Resistance Of Each Terminal Of Power Back Door (W/Power Back Door) (Disconnect Connectors)
      G02630584Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, there may be a malfunction on the wire harness side.

    2. Reconnect the ECU connectors, and check the voltage of each terminal of the connectors.

      Standard: 

      Fig 6: Checking Voltage Or Resistance Of Each Terminal Of Power Back Door (W/Power Back Door (Reconnect Connectors)
      G02630585Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, the ECU may have a malfunction.