Inspection Procedure
- Check the jam protection pulse sensor circuit using DTC check (See DIAGNOSTIC TROUBLE CODES CHECK / CLEAR
).
CHECK:
Check if DTC B1234 of the multiplex communication system is output.
OK:
DTC is not output.
- OK: Proceed to next circuit inspection shown in problem symptoms table (See PROBLEM SYMPTOMS TABLE ).
- NG: Go to next step.
- Check jam protection pulse sensor (See INSPECTION
).
- NG: Replace the power window motor.
- OK: Go to next step.
- Check wire harness and connector between jam protection pulse sensor and passenger door ECU (See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE
).
- NG: Repair or replace wire harness or connector.
- OK: Proceed to next circuit inspection shown in problem symptoms table (See PROBLEM SYMPTOMS TABLE ).