LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> Tundra Base, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Adjustments >> Brake Pedal Height

Brake Pedal Height

  1. Remove left scuff plate, left cowl side trim, instrument lower finish panel and air duct (if necessary). Disconnect and remove stoplight switch. Brake pedal height is measured from face of brake pedal pad to asphalt sheet under carpet. See Figure.
  2. Brake pedal height should be 6.46-6.85" (164-174 mm). To adjust brake pedal height, loosen lock nut on brake pedal push rod. Adjust pedal height by turning push rod.
  3. After adjusting brake pedal height, tighten push rod lock nut. Reinstall and adjust stoplight switch. See STOPLIGHT SWITCH . Check and adjust brake pedal free play. See BRAKE PEDAL FREE PLAY .
scientia non olet · About LEMON Manuals