LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2019 >> Model 3 Base >> Repair and Diagnosis >> General Information >> Hoist/Jack >> Body -- Model 3 >> Body Panels >> Fender Assembly - Front - LH - Remove and Replace >> Remove

Fender Assembly - Front - LH - Remove and Replace: Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove And Replace) .
  2. Remove the cabin intake duct. See Duct - Cabin Intake (Remove And Replace) .
  3. Remove the hood latch cover. See Cover - Hood Latch (Remove And Replace) .
  4. Remove the underhood storage unit. See Underhood Storage Unit (Remove And Replace) .
  5. Remove the front fascia. See Fascia - Front (Remove And Install) .
  6. Remove the LH headlight. See Headlight - LH (Remove And Replace) .
  7. Disconnect the electrical connectors (2x) from the front side repeater light.
    G14738996Courtesy of TESLA, INC.
  8. Remove the LH fascia side to fender bracket. See Bracket - Fascia Side To Fender - LH (Remove And Replace) .
  9. Release the two leftmost clips on the cowl screen panel from the LH front fender bracket.
    G14738997Courtesy of TESLA, INC.
  10. Remove the bolts that attach the upper LH front fender to the vehicle.
    G14738998Courtesy of TESLA, INC.
  11. Remove the bolt that attaches the lower LH front fender to the vehicle.
    G14738999Courtesy of TESLA, INC.
  12. Remove the bolt that attaches the rear LH front fender to the vehicle.
    G14739000Courtesy of TESLA, INC.
  13. Remove the bolt and nut that attach the lower LH front fender to the vehicle.
    G14739001Courtesy of TESLA, INC.
  14. Inspect the area between the upper LH front fender and the vehicle body for foam sealant. If present, carefully cut the sealant with a blade, and then separate the upper fender from the body with a plastic trim tool.
    G14739002Courtesy of TESLA, INC.
  15. Remove the LH front fender from the vehicle.
    G14739003Courtesy of TESLA, INC.
  16. Use a flat scraper blade and isopropyl alcohol (IPA) to remove the foam sealant from the LH outer shotgun panel. Any remaining sealant should be flush with the shotgun panel.
    G14739004Courtesy of TESLA, INC.
  17. Apply primer to the LH outer shotgun panel, completely covering the previous foam application area.
  18. Release the clip that attaches the LH cowl screen carrier bracket to the old LH front fender, and then remove the bracket from the fender.
    G14739005Courtesy of TESLA, INC.
  19. Remove the headlight grommet from the old LH front fender.
    G14739006Courtesy of TESLA, INC.
  20. Remove the underhood storage unit clips (3x) from the old LH front fender.
    G14739007Courtesy of TESLA, INC.
    G14739008Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals