LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2018 >> Model S 75D >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Electrical System -- Model S >> Exterior Lights >> Light - Brake - High Mounted - Remove And Replace >> Installation

Light - Brake - High Mounted - Remove And Replace: Installation

  1. Installation procedure is the reverse of removal, except for the following:
    • NOTE: Clean the affected areas before installation.
    • If the CHMSL is to be re-used, clean residual sealant from mating face.
    • Clean any residual sealant from the glass.
    • Spirit wipe and thoroughly clean glass that is next to the CHMSL.
    • Make sure that the CHMSL is correctly located.
      1. Print out the CHMSL template. Measure the "1 INCH" box to ensure the printout is properly scaled. See CHMSL Guide.
      2. Cut the templates along the dotted lines, and then attach the templates to the glass using masking tape.
        NOTE:
        G15035041Courtesy of TESLA, INC.
      3. Remove the protective backings from the tape on the CHMSL.
      4. Install the CHMSL on the glass, ensuring the CHMSL aligns with the templates.
      5. Press onto the CHMSL to adhere it to the glass.
      6. Remove the templates from the glass.
      7. Tape the CHMSL harness to the glass.
        NOTE:
        G15035042Courtesy of TESLA, INC.
    • Wipe away any excess sealant
    • Apply adhesive tape to keep the CHMSL in position and allow adhesive to cure.
scientia non olet · About LEMON Manuals