- Remove the parking distance sensor from the fascia. See:
- Remove the parking distance sensor retainer.
NOTE:
Take note of the original installation position of the retainer. Mark with a paint pen, if necessary.
NOTE:
The shape of the parking distance sensor retainer will vary slightly depending on location.
NOTE:
Use of the following tools is recommended:
- Flathead screwdriver
- Needle nose pliers
- Portable stand
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Sand down the areas of installation on the fascia and the new retainer.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Test fit the new retainer with the parking distance sensor installed. Mark the position to aid with the installation.
NOTE:
Position the retainer so that the parking distance sensor is centered to the fascia. If the retainer is installed incorrectly, the sensor will not fit.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Clean the installation areas of the fascia and retainer with an Isopropyl Alcohol (IPA) wipe.
NOTE:
Allow 1 minute for surfaces to dry before continuing.
- Prepare and mix the 3M 810 Acrylic adhesive/Scotch weld applicator (1458055-00-A).
 Courtesy of TESLA, INC.
|
- Apply the 3M 810 Acrylic adhesive to the installation area.
CAUTION:
Avoid putting excess adhesive.
CAUTION:
Apply carefully and do not allow the adhesive to seep into the center of the retainer where the sensor will seat.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Install the retainer and secure the fixture tool (Parking Sensor Retainer Kit 1638000-00-A).
CAUTION:
Prevent adhesive from entering the center hole of the retainer.
CAUTION:
Clean off any residue that may enter with an IPA wipe. Otherwise, the parking distance sensor will not seat properly.
NOTE:
Install the fixture tool to secure the retainer while adhesive cures.
NOTE:
The fixture tool is self centering.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Apply additional adhesive to the outer edge of the retainer.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Allow 20 minutes for adhesive to reach handling strength.
- Remove the retainer fixture tool.
 Courtesy of TESLA, INC.
|
- Install the parking distance sensor from the fascia. See:
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|