DTC C1412: Selected Parameter

DTC detecting condition:

VDCCM parameter selection error

Trouble symptom:

ABS does not operate.
EBD does not operate.
VDC does not operate.
Hill start assist does not operate.
Hill descent control does not operate. (Model with X mode)
EyeSight does not operate. (Model with EyeSight)

NOTE: When the VDCCM or VDCCM&H/U is replaced, this DTC may be stored.

CHECK VDCCM&H/U IDENTIFICATION SYMBOL .
Check the identification symbol attached on the H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>General Description>SPECIFICATION .

Is the identification symbol correct?

Yes: Go to 2.

No: Replace the VDCCM&H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM&H/U) .
CHECK PARAMETER SELECTED IN VDCCM .
Ref. to BRAKE CONTROL (DIAGNOSTICS)>Subaru Select Monitor>OPERATION>PARAMETER CHECK .

Does the parameter registered in the VDCCM match the relevant vehicle?

Yes: Replace the VDCCM&H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM&H/U) .

No: Select and register the correct parameter. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Subaru Select Monitor>OPERATION>PARAMETER SELECTION .