LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Push Button Ignition Switch >> Removal

Push Button Ignition Switch: Removal

  1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the cover assembly - instrument panel LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>REMOVAL .
  3. Remove the grille assembly - CTR ventilation LH. Ref. to AIR CONDITIONER>Air Vent Grille>REMOVAL>CENTER GRILLE ASSEMBLY .
  4. Remove the visor assembly - combination meter.
    1. Release the clips of the cover assembly - visor LWR.
      G12398836Courtesy of SUBARU OF AMERICA, INC.
    2. Release the screws, clips and claws.
      G11246164Courtesy of SUBARU OF AMERICA, INC.
    3. Disconnect the connector, and remove the visor assembly - combination meter.
  5. Remove the panel - starter SW.
    1. Release the claws.
    2. Detach the connectors and remove the panel - starter SW.
      G11246399Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the switch - push button start.
    G11246400Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals