LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Impreza Base, 4D Sedan, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 202 (Power Rear Gate (Service Information)) >> Power Rear Gate Control Module >> Removal

Power Rear Gate Control Module: Removal

WARNING: This page is about a different car, the 2017 Subaru Outback and 2017 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to BATTERY
    NOTE: Repair Contents.
  2. Remove the trim panel - rear apron LH. Ref. to REMOVAL , Rear Quarter Trim.
  3. Remove the power rear gate control module (PRG Control Module).
    1. Disconnect the connectors in the following order.
      1. Disconnect the connector (b).
      2. Pull the slide lock in the arrowed direction, and disconnect the connector (a) by pressing in the lock.
      3. Disconnect the connector (c).
      NOTE: When the connectors are not disconnected in the sequence, a diagnosis code (DTC) may be detected.
      Fig 1: Pulling Slide Lock
      G10309971Courtesy of SUBARU OF AMERICA, INC.
    2. Release the lock and hook, and remove the power rear gate control module (PRG Control Module).
    Fig 2: Identifying Power Rear Gate Control Module Lock And Hook
    G10309972Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals