Release Bearing and Lever: Installation

Grease 

NICHIMOLY N-130 or equivalent 

1. While pushing the release lever to the pivot and twisting it to both sides, fit the lever spring onto the raised portion of the pivot.
   NOTE: Observing from the main case hole, check that the lever spring is installed securely.
2. Install the release bearing and fasten it with two clips.
3. Install the dust cover.
   Fig 1: Identifying Release Lever And Dust Cover

   Courtesy of SUBARU OF AMERICA, INC.
4. Check the bearing for smooth movement by operating the release lever.
5. Apply grease to the contact point of the release lever and operating cylinder.

   Grease 

   NICHIMOLY N-130 or equivalent 

6. Install the transmission assembly. Refer to INSTALLATION .