LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Tribeca Premium >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Fuel Injection System (Fuel Systems) (H6DO - 3.6L DOHC) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

  1. Remove the collector cover.
  2. Disconnect the ground cable from battery.
  3. Remove the air intake chamber. Refer to AIR INTAKE CHAMBER REMOVAL, Air Intake Chamber.
  4. Remove the throttle body from the intake manifold.
    NOTE: Do not disconnect the inlet and outlet hoses of engine coolant.
  5. Remove the service hole plug.
    Fig 1: Locating Service Hole Plug
    G06649725Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the crankshaft position sensor.
    Fig 2: Locating Crankshaft Position Sensor
    G07912300Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the connector from the crankshaft position sensor.
scientia non olet · About LEMON Manuals