DTC P0500: Vehicle Speed Sensor "A": Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON and turn the Techstream on.
3. Enter the following menus: Powertrain / Engine / Data List / Vehicle Speed.
4. Drive the vehicle.
5. Read the value displayed on the Techstream.
   RESULT
   
   

   Result	Proceed to
   Values displayed on Techstream and speedometer display not equal	A
   Values displayed on Techstream and speedometer display equal	B

B → See step   4 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
5. Read DTCs. Refer to DTC CHECK / CLEAR [07/2013 - ] .
   RESULT
   
   

   Result	Proceed to
   No DTC is output	A
   No DTCs are output	B

B → See step   6 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK / CLEAR [07/2013 - ] .
5. Turn the ignition switch off and wait for at least 30 seconds.
6. Turn the ignition switch to ON.
7. Turn the Techstream on.
8. Start the engine and warm it up.
9. Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
10. Enter the following menus: Powertrain / Engine / Trouble Codes.

    Result

    Result	Proceed to
    DTC is not output	A
    DTC P0500 is output	B

B → See step   5 

A → See step   4