LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2004 >> L300 4D Sedan, 2.2 F >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.2L (L61) (Introduction) >> Repair Instructions >> Fuel Pressure Gage Installation & Removal >> Removal Procedure

Removal Procedure

  1. Ensure the fuel pump is OFF.
  2. Place the bleed hose of the SA9127E  , or the J 34730-1A  into an approved fuel container. See Special Tools and Equipment .
  3. Open the bleed valve on the SA9127E  , or the J 34730-1A  in order to bleed the fuel system pressure. See Special Tools and Equipment .
  4. Place a shop towel under the fuel pressure service connection to catch any remaining fuel spillage.
  5. Remove the SA9127E  , or the J 34730-1A  from the fuel pressure service connection. See Special Tools and Equipment .
  6. Drain any fuel remaining in the SA9127E  , or the J 34730-1A  into an approved fuel container. See Special Tools and Equipment .
  7. Inspect for leaks using the following procedure:
    1. Turn the ignition ON, with the engine OFF for 2 seconds.
    2. Turn the ignition OFF for 10 seconds.
    3. Turn the ignition ON, with the engine OFF for 2 seconds.
    4. Turn the ignition OFF.
    5. Inspect for leaks.
  8. Install the cap on the fuel pressure service connection.
    9. Fig 1: Proper Connection Of Pressure Adapter & Gage Bar Set To Fuel Rail
    GM893318Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals