Installing Main Wiring Harness
- Install repair wire in the wheel housing. Join wires as specified in the table using a crimp connector and crimping tool.
- Color coding of left and right hand sides of wires:
- Wire 1 - br/gn
- Wire 2 - br/bk
- Wire 3 - br
- Wire 4 - br/bl
- Wire 5 - br/wt
- br - brown
- bk - black
- bl - blue
- wt - white
- gn - green
- Cut wires to the correct length in the area of the disconnection point.
WIRE LENGTH
| Combination wire |
Front-end wire |
| Color |
Length [mm] |
Color |
Length [mm] |
| br/bk |
20 |
br/bk |
100 |
| br/gn |
40 |
br/gn |
80 |
| br/wt |
60 |
br/wt |
60 |
| br/bl |
80 |
br/bl |
40 |
| br |
100 |
br |
20 |
- Exercise caution when stripping insulation from wiring. Other wires must not be damaged.
- Push on the supplied heat-shrinking tubes.
- Push the large heat-shrinking tube over all wires.
- Strip 10 mm of insulation off the wires.
- Join wires using crimp connector.
- Shrink shrink-fit hoses with a hot-air gun.
- It is essential that all wires are watertight.
- Wrap commercially available PVC tape all around the area of the connection points.