Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

The condition for the DTC is no longer present.
The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.

NOTE: During normal diagnostic and/or repair verification technicians may find that the ABS, Traction control and/or Stability control indicators may be ON with NO DTCs displayed by the EBCM. Do not replace the EBCM for this condition.

If the ABS, Traction control and/or Stability control indicators are ON with no DTCs set, perform the following steps:

Remove the key from the ignition, open and close the driver's door to turn off retained accessory power, and wait 60 s.
Ignition ON, if the ABS, Traction Control and/or Stability indicators are still illuminated, operate the vehicle at speeds greater than 16 km/h (10MPH) to complete the self test. The EBCM should request all telltale indicators to turn OFF.
If the indicators remain ON with no DTCs set after the drive cycle, disconnect the battery for at least 60 s then reconnect the battery.
Operate the vehicle at speeds greater than 40 km/h (25MPH), the EBCM should request all the indicators to turn OFF.