Symptom Table
- Perform "Data Monitor" of CONSULT to check for any malfunctioning item.
- Check the malfunction combinations.
Malfunction item: x
Data Monitor Item Combination Switch Circuit INPUT 1 INPUT 2 INPUT 3 INPUT 4 INPUT 5 INPUT 6 OUTPUT 1 OUTPUT 2 OUTPUT 3 OUTPUT 4 OUTPUT 5 FR WIPER HI x x FR WIPER LOW x x FR WASHER SW x x FR WIPER INT x x INT VOLUME x x x x TURN SIGNAL R x x TURN SIGNAL L x x TAIL LAMP SW x x HI BEAM SW x x HEADLAMP SW x x LIGHT OFF SW x x PASSING SW x x AUTO LIGHT SW x x FR FOG SW x x WIPER OFF x x FR WIPER MIST x x - Identify the malfunctioning part from the agreed combination and repair or replace the part.
Malfunctioning part Repair or replace Combination switch INPUT circuit Inspect the combination switch input circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure . Combination switch OUTPUT circuit Inspect the combination switch output circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure . All Items Replace BCM. Refer to BCM : Removal and Installation . If only one item is detected or the item is not applicable to the combinations Replace combination switch. Refer to COMBINATION SWITCH : Removal and Installation . All Items are normal Check intermittent incident. Refer to Inspection .