LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1561 (Lighting System) >> Headlamp (For CANADA) - Daytime Light System >> Preliminary Check >> Inspection Parking Brake Switch Circuit

Inspection Parking Brake Switch Circuit

WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK BRAKE INDICATOR 
    1. Turn ignition switch ON.
    2. Apply parking brake.
    3. Release parking brake.

      Brake indicator in combination meter should illuminate when parking brake is applied and turn OFF when released  .

    OK or NG 

    • OK: Inspection End.
    • NG: GO TO 2.
  2. CHECK PARKING BRAKE SWITCH SIGNAL 
    1. Disconnect parking brake switch connector.
    2. Turn ignition switch ON.
    3. Check voltage between parking brake switch harness connector M11 terminal + (G) and ground.

      + (G) - Ground: Battery voltage should exist  .

      4. Fig 1: Checking Voltage Between Parking Brake Switch Harness Connector M11 Terminal + And Ground
      G03604829Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    • OK: Replace parking brake switch.
    • NG: GO TO 3.
  3. CHECK PARKING BRAKE SWITCH CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect combination meter connector.
    3. Check continuity between combination meter harness connector M24 terminal 23 (G) and parking brake switch harness connector M11 terminal + (G).

      + (G) - 23 (G): Continuity should exist  .

      4. Fig 2: Checking Continuity Between Combination Meter Connector M24 Terminal 23 And Parking Brake Switch Harness Connector M11 Terminal +
      G03604830Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    • OK: Replace combination meter. Refer to "COMBINATION METER ".
    • NG: Repair harness or connector.
scientia non olet · About LEMON Manuals