LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1397 (Rear Final Drive) >> Front Oil Seal >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Infiniti FX45 and 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply multi-purpose grease to front oil seal lips.
  2. Using the drift, install front oil seal as shown in figure.
    1. Tool number: ST30720000 (J-25405) 
    CAUTION:
    • Do not reuse oil seal.
    • When installing, do not incline oil seal.
    Fig 1: Installing Front Oil Seal Using Drift
    G02368058Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Align the matching mark of drive pinion with the matching mark A of companion flange, then install the companion flange.
    Fig 2: Aligning Matching Mark Of Drive Pinion And Companion Flange
    G02368059Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Apply gear oil on the screw part of drive pinion and the seating surface of drive pinion lock nut.
  5. Install drive pinion lock nut with the flange wrench, tighten to the specified torque. Refer to "COMPONENTS ".
    1. Tool number: KV40104000 ( - ) 
    CAUTION: Do not reuse drive pinion lock nut.
  6. Install propeller shaft. Refer to "REMOVAL AND INSTALLATION ".
    Fig 3: Installing Drive Pinion Lock Nut
    G02368060Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals