LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 846 (Brake Control System) >> Abs >> Trouble Diagnosis >> CONSULT- II Functions >> Self-Diagnosis >> Operation Procedure

Operation Procedure

WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
    CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which performs CAN communication.
  3. Turn ignition switch ON.
  4. Start engine and drive at approximately 30 km/h (19 MPH) for approximately 1 minute.
  5. After stopping vehicle, with engine running at idle speed, touch START (NISSAN BASED VHCL), ABS, SELF-DIAG RESULTS in order on CONSULT-II screen.

    If ABS is not indicated, go to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT .

    CAUTION:
    • If there is no error during CONSULT-II use, ABS warning lamp may be turned ON/OFF.
    • If START (NISSAN BASED VHCL) is touched immediately after starting engine or turning on ignition switch, ABS might not be displayed in System Selection screen. In this case, repeat operation from step 1. If it connect be shown after several attempts, ABS actuator and electric unit (control unit) may have malfunction. Repair or replace control unit.
  6. The self-diagnostic results are displayed. (If necessary, self-diagnostic results can be printed out by touching PRINT.)
    • When NO FAILURE is displayed, check ABS warning lamp.
  7. Conduct appropriate inspection from the display item list, and repair or replace malfunctioning component.
  8. Start engine and drive at approximately 30 km/h (19 MPH) for approximately 1 minute.
    CAUTION:
    • When a wheel sensor short-circuit is detected, if vehicle is not driven at 30 km/h (19 MPH) for at least 1 minute, ABS warning lamp will not turn off even if everything is normal.
    • Check again to make sure that there is no malfunction on other parts.
  9. Turn ignition switch OFF to prepare for erasing the memory.
  10. Start engine and touch START (NISSAN BASED VHCL), ABS, SELF-DIAG RESULTS, ERASE MEMORY in order on CONSULT-II screen to erase the error memory.
    CAUTION: If the error memory is not erased, re-conduct the operation from step 5 again.
  11. For final inspection, drive at approximately 30 km/h (19 MPH) for approximately 1 minute and confirm that ABS warning lamp turn OFF.
scientia non olet · About LEMON Manuals