LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2159 (Brake System) >> Basic Inspection >> Front Disc Brake >> Disc Rotor >> DISC ROTOR : Inspection >> RUNOUT

DISC ROTOR : Inspection: RUNOUT

WARNING: This page is about a different car, the 2011 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach disc rotor to wheel hub using wheel nuts at two or more positions.
  2. Inspect runout using a dial gauge placed at 10 mm (0.39 in) inside the disc edge.

    Runout limit (with it attached to the vehicle) :  Refer to "FRONT DISC BRAKE ".

    NOTE: Before measuring, make sure that wheel bearing axial end play is within the specification. Refer to "ON-VEHICLE INSPECTION AND SERVICE ".
    Fig 1: Checking Disc Rotor Runout Using Dial Gauge
    G07155287
  3. When runout exceeds limit value, displace mounting positions of disc rotor by one hole. And then find a position of the minimum value for runout.
  4. If runout is outside the specified value after performing the above operation, turn disc rotor using Tool.

    Tool number : 38-PFM90.5 (-) 

scientia non olet · About LEMON Manuals