Cruise Test - Part 3

WARNING: This page is about a different variant/trim than selected.

VEHICLE SPEED D4 POSITION
1. Confirm overdrive control switch is in ON position.
2. Confirm selector lever is in D position.
3. Accelerate vehicle using half-throttle to D4.
  GO TO 2.
CHECK SHIFT DOWN (D4 TO D3)
1. Release accelerator pedal.
2. Set overdrive control switch to OFF position while driving in D4.
3. Does A/T shift from D4 to D3 (O/D OFF)?
  Read gear position and vehicle speed .
Yes or No
1. Yes: GO TO 3.
2. No: go to 17. A/T DOES NOT SHIFT: D4 --> D3. WHEN OVERDRIVE CONTROL SWITCH ON --> OFF . Continue ROAD TEST.
CHECK ENGINE BRAKE
Does vehicle decelerate by engine brake?

Yes or No
1. Yes: GO TO 4.
2. No: go to 15. ENGINE SPEED DOES NOT RETURN TO IDLE (LIGHT BRAKING D4 --> D3) . Continue ROAD TEST.
CHECK SHIFT DOWN (D3 TO D2)
1. Move A/T selector lever from D to 2 position while driving in D3 (O/D OFF).
2. Does A/T shift from D3 (O/D OFF) to D2?
  Read gear position .
Yes or No
1. Yes: GO TO 5.
2. No: go to 18. A/T DOES NOT SHIFT: D3 --> 2(2). WHEN SELECTOR LEVER D --> 2 POSITION Continue ROAD TEST.
CHECK ENGINE BRAKE
Does vehicle decelerate by engine brake?

Yes or No
1. Yes: GO TO 6.
2. No: go to 15. ENGINE SPEED DOES NOT RETURN TO IDLE (LIGHT BRAKING D4 --> D3) . Continue ROAD TEST.
CHECK SHIFT DOWN
1. Move A/T selector lever from 2 to 1 position while driving in 2₂ .
2. Does A/T shift from 2₂ to 1₁ position?
  Read gear position .
Yes or No
1. Yes: GO TO 7.
2. No: go to 19. A/T DOES NOT SHIFT: 2(2) --> 1(1), WHEN SELECTOR LEVER 2 --> 1 POSITION . Continue ROAD TEST.
CHECK ENGINE BRAKE
Does vehicle decelerate by engine brake?

Yes or No
1. Yes:
  1. Stop vehicle.
  2. Perform self-diagnosis. Refer to TCM SELF-DIAGNOSTIC PROCEDURE (NO TOOLS) .
2. No: go to 20. VEHICLE DOES NOT DECELERATE BY ENGINE BRAKE . Continue ROAD TEST.