3. Check Harness Continuity 1

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF.
Disconnect automatic drive positioner control unit and door mirror LH.
Check continuity between automatic drive positioner control unit connector M34 terminal 33, 41 and door mirror LH connector D4 terminal 5, 6.
33 (W/L) - 5 (W/L) : Continuity should exist.

41 (W/G) - 6 (W/G) : Continuity should exist.
Check continuity between automatic drive positioner control unit connector M34 terminal 33, 41 and ground.
33 (W/L) - 3 Ground : Continuity should not exist.

41 (W/G) - 5 Ground : Continuity should not exist.

Fig 1: Checking Continuity

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK >> GO TO 4.
NG >> Repair or replace harness.