Mirror Motor RH Circuit Check
WARNING: This page is about a different car, the 2006 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK DOOR MIRROR RH MECHANISM
Check the following items.
Operation malfunction caused by a foreign object caught in door mirror face edge.
OK or NG
OK : GO TO 2.
NG : Repair the malfunctioning parts, and check the symptom again.
- CHECK FUNCTION
With CONSULT-II
Check the operation with "MIRROR MOTOR RH" in the ACTIVE TEST.
CONSULT-II FUNCTIONTest item Description MIRROR MOTOR RH The mirror motor RH moves the mirror UP/DOWN and LEFT/RIGHT by receiving the drive signal. Without CONSULT-II
GO TO 3.
OK or NG
OK : Mirror motor RH circuit is OK.
NG : GO TO 3.
- CHECK DOOR MIRROR RH CIRCUIT HARNESS CONTINUITY
- Turn ignition switch OFF.
- Disconnect automatic drive positioner control unit and door mirror RH.
- Check continuity between automatic drive positioner control unit connector M33 terminals 14, 15, 30 and door mirror RH connector D107 terminals 1, 2, 3.
14 - 1 : Continuity should exist.
15 - 2 : Continuity should exist.
30 - 3 : Continuity should exist.
- Check continuity between automatic drive positioner control unit connector M33 terminals 14, 15, 30 and ground.
14 - Ground : Continuity should not exist.
15 - Ground : Continuity should not exist.
30 - Ground : Continuity should not exist.
OK or NG
OK : GO TO 4.
NG : Repair or replace harness.
- CHECK MIRROR MOTOR SIGNAL
- Turn ignition switch to ACC.
- Check voltage between door mirror RH connector and ground.VOLTAGE SPECIFICATIONS
Connector Terminals Condition Voltage (V) (Approx.) (+) (-) D107 1 Ground Mirror motor is operated UP 1.5 - Battery voltage Other than above 0 2 Mirror motor is operated LEFT 1.5 - Battery voltage Other than above 0 3 Mirror motor is operated
DOWN or RIGHT1.5 - Battery voltage Other than above 0
OK or NG
OK : Replace door mirror RH. Refer to DOOR MIRROR ASSEMBLY .
NG : Repair or replace harness.