DTC 71: (Control Unit)
- Turn ignition Off. Disconnect ABS actuator/control unit 31 pin harness connector. Check terminals for damage or loose connections. If a problem is found, repair as necessary. Reconnect harness connector. Perform self-diagnostics again. See SELF-DIAGNOSTICS . Check ABS warning light. If ABS warning lamp stays on, go to next step. If ABS warning lamp does not stay on, system is okay.
- Check ABS actuator/control unit power supply circuit. See DIAGNOSTIC PROCEDURE NO. 3 (Power Supply/Low Voltage) under DIAGNOSTIC TESTS. If battery voltage is present, go to next step. If power supply circuit test as specified, or does not is not present, repair as necessary.
- Using scan tool, check for ABS related DTCs. If DTC resets, replace ABS actuator/control unit. If DTC does not reset, system is okay.