Section 96 (Adaptive Cruise Control System (Acc) (With Diagnostics))
WARNING: This page is about a different car, the 2018 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Adaptive Cruise Control (Acc) System Diagnosis
- Check Chart For Diagnostic Trouble Codes
- Check Chart For Trouble Symptoms
- Diagnostic Trouble Code Procedures
- DTC C1394: Incompleted Learn Neutral (SAS)
- DTC C1707: Implausible Coding Data
- DTC C1750: ACC-ECU Voltage Out Of Range
- DTC C1751: ACC-ECU Failure
- DTC C1752: ACC/FCM Radar Temperature out of Range
- DTC C1753: ACC/FCM Radar Blockage Detected
- DTC C1754: ACC/FCM Radar Calibration Not Completed
- DTC C1768: Alignment Left Compensation
- DTC C1769: Alignment Right Compensation
- DTC C1770: Reflector Plate In The Lowermost
- DTC C1771: Reflector Plate In The Uppermost
- DTC C1772: Alignment Sensor Too Far Right
- DTC C1773: Alignment Sensor Too Far Left
- DTC C1774: Alignment Sensor Too Low
- DTC C1775: Alignment Sensor Too High
- DTC C1776: Received ACC Failure From Engine Control Module
- DTC C1777: Received ACC Failure From ASC-ECU
- DTC C1778: Vehicle Speed Signal Failure
- DTC C1779: Brake Master Pressure Signal Failure
- DTC C1780: ASC CAN Signal Failure
- DTC C1781: SAS Failure
- DTC C1782: SAS Signal Failure
- DTC C1783: ACC Distance Switch Fixed On
- DTC C1785: Fault Detection Signal Failure
- DTC C1786: Received Limp Home From Transaxle Control Module
- DTC U0100: Engine CAN Timeout
- DTC U0101: T/M CAN Timeout
- DTC U0121: ABS/ASC CAN Timeout
- DTC U0126: SAS CAN Timeout
- DTC U0141: ETACS CAN Timeout
- DTC U1195: Coding not Completed
- Symptom Procedures
- Inspection Procedure 1: Scan tool (M.U.T.-III) Cannot Communicate With ACC System Is Impossible
- Inspection Procedure 2: Cruise Control Cannot Be Set (No Response SET - Switch is Pressed)
- Inspection Procedure 3: The Cruise Control Is Cancelled Although The Switch Is Not Operated During The ACC Operation
- Inspection Procedure 4: When The ACC Distance Switch Is Operated, The Distance From Vehicle Travelling In Front Cannot Be Changed
- Data List Reference Table
- Check At Acc/FCM Ecu Terminal
- Special Tools
- On-Vehicle Service
- Cruise Control Switch
- Acc-Ecu