LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2007 >> Lancer Automatic >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2004-05 Endeavor, GALANT, Lancer, Montero & Outlander >> Pattern 16 >> Test Procedure

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Accelerate with throttle position sensor output more than 4.2 volts for 5 seconds. (During the monitor)
  3. Stop at safe place and turn the ignition switch to "LOCK" (OFF) position.
  4. Start the engine and do Steps 1 to 3 again
  5. Confirm that the diagnostic trouble code (DTC) is not output.
scientia non olet · About LEMON Manuals