Other Monitors

DTCs Monitored

Monitor Type	DTCs
Main components	P0134, P0300, P0301, P0302, P0303, P0304, P0506, P0507, P1400
Sensors and switches	P0101, P0102, P0106, P0107, P0108, P0111, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0125, P0335, P0340, P0510, P0551
Wire breakage and short circuit	P0132, P0135, P0137, P0138, P0141, P0201, P0202, P0203, P0204, P0403, P0443, P0446, P1500

Test requirements and procedure

All of the following requirements should be met when carrying out a drive test.
1. Engine coolant temperature: 80°C (176°F) or more (Engine fully warmed up)
2. Atmospheric temperature: 5°C (41°F) or more
3. Condition of A/T: Selector lever position: D range
One trip monitor will be completed by driving according to the steps below (from start to switch off). It will take approx. 10 minutes.
1. After warming up, turn off the ignition switch.
2. Start the engine, accelerate to 56 - 64 km/h (35 - 40 mph), continue driving for 300 seconds or more at that speed range and stop. Moreover, brake or throttle may be applied for this period.
3. After stopping the vehicle, continue idling for 300 seconds or more, and then turn off the ignition switch. Moreover, the vehicle should be set to the following conditions for idling.
  - A/C switch: OFF
  - Lights, electric cooling fan and all accessories: OFF
  - Transaxle: Neutral (A/T for P range)
  - Steering wheel: Straight-forward position

Fig 1: Drive Cycle Pattern For Other Monitoring

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.