Comfort Access Locking Requires Multiple Button Presses (SI M66 01 17)
Reference number: SI M66 01 17
COMFORT ACCESS LOCKING REQUIRES MULTIPLE BUTTON PRESSES
TECHNICAL SERVICE BULLETIN
| MINI: | F54 (Cooper, Cooper S Clubman); F55 (Cooper, Cooper S Hardtop 4 door); F56 (Cooper, Cooper S Hardtop 2 door); F57 (Cooper, Cooper S Convertible); Vehicles produced from December 01, 2013 through July 01, 2016 with option code 0322 Comfort Access (CA) |
| GROUP: | Drivers Assistance, Remote Control Systems |
SITUATION
Locking vehicle with CA button requires two presses, with up to 3 second delay between presses.
CAUSE
Body Domain Controller (BDC) software
CORRECTION
Program vehicle to integration level F056-16-07-501 and higher.
Parts replacement will not correct this situation.
PROCEDURE
For conditions that are similar to the situation described:
- Perform diagnosis with the latest version of ISTA.
- Program the vehicle using ISTA 4.04.12 or higher.
| F54, F55, F56, F57 | Target integration level: F056-16-07-501 or higher |
Note that ISTA 4 will automatically reprogram and code all programmable control modules that do not have the latest software.
Always connect a BMW approved battery charger/power supply ( SI M04 08 09 ).
For information on programming and coding with ISTA 4, refer to CenterNet/TIS/Technical Documentation/Diagnostics and Programming/Programming Documentation.
WARRANTY INFORMATION
Covered under the terms of the MINI New Passenger Car Limited Warranty or the MINI NEXT/MINI Certified Pre-Owned Limited Warranty.
| Defect Code: | 6138270200 | |
|---|---|---|
| Labor Operation: | Labor Allowance: | Description: |
| 00 00 006 | Refer to KSD2 | Performing "vehicle test" (with vehicle diagnosis system - checking faults) (Main work) |
| Or: | ||
| 00 00 556 | Refer to KSD2 | Performing "vehicle test" (with vehicle diagnosis system - checking faults) (Plus work) |
| And: | ||
| 61 21 528 | Refer to KSD2 | Connect an approved battery charger/power supply (indicated in KSD 2 as Charging battery) |
| And: | ||
| 61 00 730 | Refer to KSD2 | Programming/encoding control unit(s) |
If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead.
Refer to KSD2 for the corresponding flat rate unit (FRU) allowances.
Vehicle Programming and Coding
When ISTA 4 automatically reprograms and codes all the vehicle's control modules that "currently do not have" the latest software and if one or more control module failures occur "during" this programming procedure:
- Please claim this "consequential" control module-related repair work under the defect code listed in this bulletin with the applicable KSD2/AIR labor operations.
Other Repairs
Control module failures that occurred "prior" to performing this programming procedure:
- When "covered" under an applicable limited warranty, claim this control module-related repair work using the applicable defect code and labor operations in KSD2/AIR.