Remove/install regulator for alternator - AR15.40-P-5760SMG
ENGINE 156 in MODEL 216, 221
| Remove/install | |||
|---|---|---|---|
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. | Keep body parts and limbs well clear of moving parts. | AS00.00-Z-0011-01A | |
| Risk of death caused by vehicle slipping or toppling off the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of explosion caused by oxyhydrogen gas. Risk of poisoning and caustic burns caused by swallowing battery acid. Risk of injury caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries | No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers. | AS54.10-Z-0001-01A | |
| 1 | Disconnect ground line from battery | AR54.10-P-0003SX | |
| Notes on battery | All models | AH54.10-P-0001-01A | |
| 2 | Open engine hood | ||
| 3 | Raise vehicle with lifting platform | AR00.60-P-1000SX | |
| 4 | Remove lower engine compartment paneling | AR61.20-P-1105SX | |
| 5 | Unscrew bolts (4) at regulator (5) | *BA15.40-P-1006-01P | |
| 6 | Take out regulator (5) | ||
| 7 | Install in the reverse order | ||
| 8 | Perform basic programming | ||
| Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. |
AS00.00-Z-0005-01A | |
| 9 | Carry out engine test run |
ALTERNATOR
| Number | Designation | Engine 156 | ||
|---|---|---|---|---|
| BA15.40-P-1006-01P | Bolt connecting regulator to alternator | Nm | 2.8 | |
| M4 x 13 | Nm | 1.2 | ||
| M4 x 19 | Nm | 2.5 |