Rear Mount Camera Inspection
NOTE:
- The integrity of the rear mount camera cannot be determined from a single part. When inspecting the rear mount camera, perform the following procedure.
Without 360° view monitor system
- Connect the M-MDS to the DLC-2.
- Perform the DTC inspection for the connectivity master unit (CMU) and verify if any DTCs related to the rear mount camera is detected. (See DTC INSPECTION
.)
- If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting. (Refer to the [DTC TABLE [CONNECTIVITY MASTER UNIT (CMU)]] in the workshop service information)
With 360° view monitor system
- Connect the M-MDS to the DLC-2.
- Perform the DTC inspection for the 360° view monitor control module and verify if any DTCs related to the rear mount camera is detected. (See DTC INSPECTION
.)
- If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [360° VIEW MONITOR CONTROL MODULE (US)] .)