Diagnostic Procedure
DTC U3000:4A (DYNAMIC STABILITY CONTROL (DSC)) DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | INSPECT DSC HU/CM FOR MISMATCHED INSTALLATION
|
Yes | Go to the next step. |
| No | Replace with correct DSC HU/CM part number, then go to Step 3. (See DSC HU/CM REMOVAL/INSTALLATION .) |
||
| 2 | INSPECT INSTRUMENT CLUSTER CONFIGURATION
|
Yes | Go to the next step. |
| No | Configure instrument cluster properly, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION (USING READ/WRITE FUNCTION) .) (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) .) |
||
| 3 | VERIFY DTC TROUBLESHOOTING COMPLETED
|
Yes | Repeat the inspection from Step 1. |
| No | Go to the next step. | ||
| 4 | VERIFY NO DTC IS PRESENT
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE (DYNAMIC STABILITY CONTROL (DSC)) .) |
| No | DTC troubleshooting completed. | ||