Cylinder Head Cover Removal Note

Disconnect the connectors and clips shown in the figure and set the wiring harness aside.

Fig 1: Connectors, Clips And Wiring Harness

Courtesy of MAZDA MOTORS CORP.

COMPONENT DESCRIPTION

1	Wiring harness clip
2	Wiring harness clip
3	Wiring harness clip
4	Wiring harness clip
5	Purge solenoid valve connector
6	Solenoid valve connector
7	Wiring harness clip

Disconnect the hoses shown in the figure and remove the purge solenoid bracket component.

Fig 2: Locating Hoses And Purge Solenoid Bracket Component
Courtesy of MAZDA MOTORS CORP.
Remove the bolts shown in the figure and remove the bracket.

Fig 3: Bolts, Bracket And Cylinder Head Cover
Courtesy of MAZDA MOTORS CORP.

Remove the bolts and clips shown in the figure and remove the wiring harness bracket.

Fig 4: Wiring Harness Bracket, Bolts And Clips

Courtesy of MAZDA MOTORS CORP.

COMPONENT DESCRIPTION

Set the engine wiring harness aside using the following procedure:

Disconnect or remove the following parts.

Step 1

Fig 5: Engine Wiring Harness And Clips (Step 1)

Courtesy of MAZDA MOTORS CORP.

COMPONENT DESCRIPTION

Step 2

Fig 6: Engine Wiring Harness And Clips (Step 2)

Courtesy of MAZDA MOTORS CORP.

COMPONENT DESCRIPTION

1	Wiring harness clip
2	Fuel pressure sensor connector
3	High pressure fuel pump connector
4	Bolt
5	Camshaft position (CMP) sensor connector
6	Wiring harness clip

Set the engine wiring harness in a place which does not interfere with the servicing.

Disconnect the hoses shown in the figure and remove the vacuum pipe component.

Fig 7: Locating Vacuum Pipe Component
Courtesy of MAZDA MOTORS CORP.
Disconnect the vacuum hose.

Fig 8: Vacuum Hose And Clip
Courtesy of MAZDA MOTORS CORP.
Disconnect the hose shown in the figure and set the air pipe component aside with the water hose still connected.

Fig 9: Air Pipe Component, Bolt And Clip
Courtesy of MAZDA MOTORS CORP.
Remove the bolt shown in the figure and remove the wiring harness bracket.

Fig 10: Wiring Harness Bracket And Bolt
Courtesy of MAZDA MOTORS CORP.
Remove the air inlet pipe. (U.S.A. and CANADA) (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
Disconnect the air intake hose shown in the figure. (U.S.A. and CANADA)

Fig 11: Air Intake Hose, Hose Clamp And Cylinder Head Cover (USA And CANADA)
Courtesy of MAZDA MOTORS CORP.
Disconnect the breather hose shown in the figure. (Except U.S.A. and CANADA)

Fig 12: Breather Hose, Cylinder Head Cover And Clip (Except USA And CANADA)
Courtesy of MAZDA MOTORS CORP.
Remove the cylinder head cover.