Auto Leveling Sensor Removal/Installation

Disconnect the negative battery terminal. (Refer to NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
While pressing the clip tabs in the direction of arrows (1) shown in the figure, press the clip in the direction of arrow (2) to detach the clip tabs from the auto leveling sensor.

Fig 1: Pressing Clip Tabs
Courtesy of MAZDA MOTORS CORP.
Disconnect the connector.
Remove the bolts.

Fig 2: Removing Bolts
Courtesy of MAZDA MOTORS CORP.
Pull out the hooks from the rear crossmember.

Fig 3: Pulling Out Hooks From Rear Crossmember
Courtesy of MAZDA MOTORS CORP.
Remove the auto leveling sensor.
Install in the reverse order of removal.
Perform headlight auto leveling system initialization. (Refer to HEADLIGHT AUTO LEVELING SYSTEM INITIALIZATION .)