Rear Door Lock-Link Inspection

Fully open the rear door glass.
Disconnect the negative battery cable.
Remove the following parts:
1. Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION .)
2. Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
3. Rear inner handle (See INNER HANDLE REMOVAL/INSTALLATION .)
4. Rear door speaker (See REAR DOOR SPEAKER REMOVAL/INSTALLATION .)
5. Rear door quarter glass (See REAR DOOR QUARTER GLASS REMOVAL/INSTALLATION .)
6. Rear door glass (See REAR DOOR GLASS REMOVAL/INSTALLATION .)
7. Rear door module panel (See REAR DOOR MODULE PANEL REMOVAL/INSTALLATION .)
8. Rear door latch and lock actuator (See REAR DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION .)
If the door lock condition is to be inspected, pull the door lock-link switch cable, or press it in.
NOTE:
- The door lock-link switch cable locks or unlocks only when the latch lever is locked.
  
  Fig 1: Identifying Door Lock-Link Switch Cable
Verify that the continuity is as indicated in the table.

Fig 2: Identifying Door Lock-Link Switch Terminals - LH

Fig 3: Identifying Door Lock-Link Switch Terminals - RH
- If not as indicated in the table, replace the front door latch and lock actuator.
  
  Fig 4: Door Lock-Link Switch Terminals Continuity Chart