LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring Plus >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body System [Doors And Liftgate] >> Front Door Module Panel Removal/Installation

Front Door Module Panel Removal/Installation

  1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm {3.1 in}  .
    Fig 1: Identifying Distance From Top Of Front Door Glass To Upper Part Of Front Beltline Molding
    G08144294
  2. Disconnect the negative battery cable.
  3. Remove the following parts:
    1. Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION .)
    2. Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
    3. Front door speaker (See FRONT DOOR SPEAKER REMOVAL/INSTALLATION .)
    4. Front door glass (See FRONT DOOR GLASS REMOVAL/INSTALLATION .)
    5. Pressure sensor connector (See PRESSURE SENSOR REMOVAL/INSTALLATION .)
  4. Remove the clips securing the front door wiring harness from the front door module panel.
    Fig 2: Identifying Clips, Front Door Wiring Harness And Front Door Module Panel
    G08144295
  5. Remove the bolts.
    Fig 3: Identifying Front Door Module Panel, Fastener And Bolts
    G08144296
  6. Remove the fastener.
  7. Remove the front door module panel.
  8. Remove the front power window motor. (See POWER WINDOW MOTOR REMOVAL/INSTALLATION .)
  9. Remove the front power window regulator. (See FRONT POWER WINDOW REGULATOR REMOVAL/INSTALLATION .)
  10. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals