Crankshaft Position (CKP) Sensor - 3.0L (4V) Removal/Installation

Fig 1: Crankshaft Position (CKP) Sensor With Torque Specifications -- 3.0L (4V) Replacement Components

Courtesy of MAZDA MOTORS CORP.

1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
2. Remove the 5 bolts and the RH splash shield.
   Fig 2: Identifying (RH) Splash Shield Bolts

   Courtesy of MAZDA MOTORS CORP.
   • To install, tighten to 9 N.m {0.9 kgf.m, 80 in.lbf}.
3. Disconnect the crankshaft position (CKP) sensor electrical connector.
4. Remove the bolt and the CKP.
   • To install, tighten to 10 N.m {1.0 kgf.m, 89 in.lbf}.
   • Inspect the O-ring seal and install new as necessary.
5. To install, reverse the removal procedure.
   NOTE:

   • Lubricate the CKP O-ring seal with clean engine oil.