Removal and Installation

All vehicles 

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .

   All vehicles except Gasoline Turbocharged Direct Injection (GTDI) 

2. Remove the LH catalytic converter. For additional information, refer to EXHAUST SYSTEM .
3. Remove the bolt, nut and the heat shield.
   • To install, tighten to 10 Nm (89 lb-in).

   GTDI vehicles 

4. Remove the LH turbocharger. For additional information, refer to FUEL CHARGING AND CONTROLS - TURBOCHARGER .
5. Remove the nut and the heat shield.
   • To install, tighten to 10 Nm (89 lb-in).

   All vehicles 

6. Remove the rubber grommet cover.
7. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
8. Remove the bolt and the CKP sensor.
   • To install, tighten to 10 Nm (89 lb-in).
9. To install, reverse the removal procedure.

   GTDI vehicles 

10. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.