LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2009 >> Navigator RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Parking Aid System >> General Procedures >> Azimuth System Check

Azimuth System Check

Expedition 

Minimum Detectable Object Locations 

Fig 1: Identifying Minimum Detectable Object Locations
G06133568Courtesy of FORD MOTOR CO.
    NOTE: The object used in this system check can be fabricated from 9 cm O.D. (3 in I.D.) plastic pipe, 100 cm (39 in) length (available as Polyvinyl Chloride (PVC) pipe, or similar from a hardware or plumbing supply).
    NOTE: This system check should be carried out with the vehicle on a level surface.
    NOTE: The parking aid system will default to on when the ignition key is cycled from OFF to ON.
  1. Turn the ignition to the ON position, engine off.
  2. Set the parking brake on.
  3. Place the gearshift in REVERSE (R).
  4. Verify that the parking aid system detects the specified object when placed within the 5 specified locations (P1, P2, P3, P4 and P5). These zones are shown ideally and are not absolute. The pipe should be inside of the locations.
    • The sounder should beep slowly when objects are detected on the outer edges of the detection zone, and increase as the object is moved closer to the vehicle. When the object is within 46 cm (18 in) of the rear bumper, the sounder should sound continuously.
    • If the Parking Aid Module (PAM) does not detect the object above, refer to PARKING AID - EXPEDITION .

Navigator - Front Sensors 

Minimum Detectable Object Locations 

Fig 2: Front Sensors Minimum Detectable Object Locations
G06075463Courtesy of FORD MOTOR CO.
    NOTE: The object used in this system check can be fabricated using a 9 cm diameter (3 in I.D.) plastic pipe, 100 cm (39 in) in length (available as Polyvinyl Chloride (PVC) pipe, or similar from a hardware or plumbing supply).
    NOTE: This system check should be carried out with the vehicle on a level surface.
    NOTE: The parking aid system defaults to on when the ignition key is cycled from OFF to ON.
  1. Turn the ignition switch to the ON position, engine off.
  2. Apply the parking brake.
  3. Place the gearshift in DRIVE (D) or REVERSE (R).
  4. Verify that the parking aid system detects the object above when placed in the 5 specified locations (P1, P2, P3, P4 and P5).

Navigator - Rear Sensors 

Minimum Detectable Object Locations 

Fig 3: Rear Sensors Minimum Detectable Object Locations
G06065152Courtesy of FORD MOTOR CO.
    NOTE: The object used in this system check can be fabricated using a 9 cm diameter (3 in I.D.) plastic pipe, 100 cm (39 in) in length (available as Polyvinyl Chloride (PVC) pipe, or similar from a hardware or plumbing supply).
    NOTE: This system check should be carried out with the vehicle on a level surface.
    NOTE: The parking aid system defaults to on when the ignition key is cycled from OFF to ON.
  1. Turn the ignition switch to the ON position, engine off.
  2. Apply the parking brake.
  3. Place the gearshift in REVERSE (R).
  4. Verify that the parking aid system detects the object above when placed in the 5 specified locations (P1, P2, P3, P4 and P5).
scientia non olet · About LEMON Manuals