Remove & Install or Remove & Replace
WARNING: This page is about the RX 350 Base, AWD, which is a different variant/trim than selected.
DOES NOT include alignment.
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| AWD, Both | Includes: Confirm Fluid temperature for level check. | 3.4 | 2.1 | B |
| AWD, One Side | Includes: Confirm Fluid temperature for level check. | 2.4 | 1.6 | B |
| Combination Procedure: AXLE SHAFT: Replace: NOTE: For Independent Suspension Type Axles, this operation consists of dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft. | ||||
| Left Side | 1.0 | B | ||
| Right Side,Inboard | 0.7 | B | ||
| Right Side,Outboard | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT BOOT: Remove & Replace: | ||||
| Inner &/or Outer,Each Side | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT SUPPORT BEARING: Remove & Replace: | ||||
| 0.7 | B | |||
| Combination Procedure: CONSTANT VELOCITY JOINT: Remove & Replace: | ||||
| Each | 0.5 | B | ||
| Combination Procedure: TRANSAXLE OUTPUT SEAL: Remove & Replace: | ||||
| AWD, Left Side | 0.2 | B | ||
| AWD, Right Side,Transaxle Output Seal | Includes: R&I Transfer Case Assembly. Includes: R&I Transaxle Assembly. Includes: R&I Suspension Crossmember Assembly. DOES NOT include wheel alignment. | 9.8 | B | |
| AWD, Right Side,Transfer Case Oil Seal | 0.2 | B | ||