Installation [09/2014 - ]: Procedure

1. Install the purge valve (purge VSV) to the intake air surge tank assembly with the bolt.

   Torque: 21 N.m (214 kgf/cm, 15 ft.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Fuel Vapor Feed Hose	*2	No. 1 Fuel Vapor Feed Hose
   *a	1 to 5 mm (0.0394 to 0.197 in.)	*b	30° to 60°
   *c	40° to 60°	*d	90°
   *e	Paint Mark	*f	Upper
   *g	Under	*h	Back

   HINT: 

   Make sure the direction of the purge valve (purge VSV) is as shown in the illustration.

2. Connect the purge valve (purge VSV) connector.
3. Connect the No. 1 fuel vapor feed hose to the purge valve (purge VSV) and slide the clip to secure it.

   HINT: 

   Engage the clip within the area shown in the illustration.

4. Connect the fuel vapor feed hose to the purge valve (purge VSV) and slide the clip to secure it.

   HINT: 

   Engage the clip within the area shown in the illustration.

Refer to PROCEDURE - Step 96 [09/2014 - 05/2018] , or refer to PROCEDURE - Step 97 [05/2018 - 03/2019] , or refer to PROCEDURE - Step 96 [03/2019 - ]