Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Battery terminal is disconnected/reconnected	Memorize steering angle neutral point	LKA /LDA system	Refer to INITIALIZATION [09/2015 - 08/2019]
		Pre-collision system
		Intelligent clearance sonar system*1
		Lighting system (w/ Automatic Headlight Beam Level Control System)	Refer to INITIALIZATION [09/2015 - 08/2019]
		AFS (Adaptive Front-lighting System)	Refer to INITIALIZATION [09/2015 - 08/2019]
		Parking assist monitor system	Refer to INITIALIZATION [09/2015 - 08/2019]
		Panoramic view monitor system	Refer to INITIALIZATION [09/2015 - 08/2019]
	Initialize back door lock	Power door lock control system	Refer to INITIALIZATION [09/2015 - ]
	Reset back door close position	Power back door system	Refer to INITIALIZATION [09/2015 - 08/2019]
Replacement of knock control sensor	Inspection after repair	Poor idle, etc. Engine start function, etc.	Refer to INITIALIZATION [09/2015 - 08/2019]

*1: When performing learning using the Techstream.

Refer to CALIBRATION [08/2016 - 12/2017] , or refer to CALIBRATION [12/2017 - 08/2019]

WARNING:

To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.